OUTPUT CAMSHAFT SENSOR

OUTPUT CAMSHAFT SENSOR

Descripción del producto:

Ferrari part number 235485 is an output camshaft sensor for the Ferrari 430. It is used to monitor the position of the exhaust camshaft and send this information to the engine control unit (ECU). The ECU uses this information to time the fuel injection and spark timing, as well as to control other engine functions.

A faulty output camshaft sensor can cause a variety of problems, including:

• Engine misfire
• Rough idle
• Hesitation
• Reduced fuel economy
• Check engine light

If you are experiencing any of these problems, it is important to have the output camshaft sensor checked by a qualified mechanic.

The output camshaft sensor is a relatively inexpensive part to replace, but the labor costs can be significant. The best way to avoid costly repairs is to have the sensor regularly checked and replaced as needed.

Here are the steps on how to replace a camshaft sensor:

1. Disconnect the negative battery cable.
2. Locate the camshaft sensor.
3. Remove the connector.
4. Remove the sensor.
5. Take the cam sensor out.
6. Install a new O-ring seal.
7. Install the sensor.
8. Clear the existing codes.

It is important to note that the exact steps may vary depending on the make and model of your car. It is always best to consult your car\'s owner\'s manual or a qualified mechanic for the specific instructions.

Este recambio es adecuado para los siguientes modelos:
430 Scuderia, 430 Scuderia Spider 16M